4.6L Spacer
Sent in by John of Low-ET Performance
MW
Note: Here is some info sent in to us describing a spacer for
the 4.6L. Intake spacers have existed for 5.0's and others for boosting
performance by either lowering heat transfer or changing flow characteristics.
The 4.6L intake is plastic, but here is some info on their product with
some dyno samples:
The white car on the dyno has
x pipe and flowmaster, pulleys and a l.e.t chip 2000 GT customer is Thomas.

4.6L intake Spacer
1. remove inlet
tube from t.b. disconect t.p.s. plug also iac plug so its easy to lift
up dog house were running horse logo is.
2. remove 5 bolts using 8mm deep socket 1 bolt is just a brace for upper
dog house. {look at spacer picture you will only see 4 bolt holes}
3. slip spacer under dog house @ lower plastic intake line up bolt holes
and reuse factory bolts .final reconect inlet tube and sensor plugs

Without Spacer
With Spacer
For more info
on spacer contact john @ LOW-E.T. PERFORMANCE
516-997-0204 OR EMAIL prostocktruck@netzero.com
Back
to Mustangworld.com
MUSTANGWORLD.COM,
the Mustangworld crest logo above and MOLLERNET are registered
trademarks of MoLLER DIGITAL / DiscMEDIA INC. Copyright ©
1986 - 1998 MoLLER DIGITAL. Some web elements on this site are
copyrighted and are being used with permission from their respective
owners. MUSTANGWORLD web elements may not be "re-posted" on any
website anywhere in the free world without permission from MoLLER
DIGITAL INC. All original graphics are digitally watermarked to
aid us in copyright enforcement.
.
|
|