MWspeedshop.com


Select Stangs



Beefcake's Mustang


Exterior mods on the car so far are cervinis 4" cowl hood, cdc agressive chin spoiler, streetscene rear valance, steeda wing, short antenna, and elanor grille kit paint was done by one of my local stangbangerz buddies, he also painted the strut tower brace on the engine.

Wheels are american racing rogues, 20x10 rear with 295's and fronts are 20x8.5 with 255's. Wheels are wrapped with Toyo Proxes 4's.

Suspension mods include aje strut tower brace, roush rear lowering springs, steeda front lowering springs, adj panhard bar, 3rd link, lower trailing arms, and rear sway bar w/sway bar bushings

The interior features a hurst short throw shifter along with corbeau legacy (lg1) seats and a hurst short throw shifter.

Performance mods so far are subtle, they include a cold air intake, 3.90 gears, and are dyno tuned by MD Motorsports in Cincinnati. The car put down 284 rwhp and 300 ft/lbs. It ran 101 mph in the 1/4 mile after putting the 20's on. The car was then fitted with Stainless Works 1 3/4" Long tube headers and a full 3" stainless works exhaust. and stainless works 3" axle back exhaust.

With the new 20's , the car only put down 283/293, but it ran 106 mph in the 1/4 mile. So, the wheels are sucking up a lot of HP, but they look good.

The car is getting ready to be fit with a Procharger P-1sc-2 along with a snow performance meth kit. I will also be adding an alum driveshaft, cobra 39lb injectors, kb boost a pump and cobalt gauges and tach with shift light. These mods should be done in the next 6-8 weeks along with some slicks for the track to free up some more hp!

 

 


Back to Mustangworld.com


Mustangworld Shop

Copyright © 1986 - 2006 Some web elements on this site are copyrighted and are being used with permission from their respective owners.